Reset To Default Settings - Telecom Behnke 21-2906A-IP Anleitung

2.5. Reset to default settings

▸
Disable the camera's power supply
▸
Press and hold the reset key
▸
Continue to hold the reset key and enable the
camera's power supply
▸ When the LEDs start flashing yellow (after
approx. 15 - 30 seconds), you may let go of
the key
www.behnke-online.com
Configuration and set-up
The following settings must be performed
again after the reset:
▸
1. Assign camera password
▸
2. Capture Mode: 1080P (1920x1080)
▸
3.Powerline frequency: 50 Hz.
▸
4. Password Settings: unencrypted only
▸ 5. Wide dynamic range: off
!
These settings should only be
carried out if sufficient knowledge
of the AXIS web frontend is
available.
IP camera Instructions
GB
25