IKEA FORSNAS Bedienungsanleitung Seite 10

ENGLISH
The defrost water automatically runs into the drain
outlet and then into a container where it evaporates.
CAUTION!
The refrigerator accessories must not
be placed in a dishwasher.
Cleaning the door gasket
• The door gasket can be removed
for cleaning purposes.
• Wipe or wash the door
gasket with clear water and
dry thoroughly with a cloth.
Then reinstall it correctly.
•
Keep the door gasket free of oil
and grease.
•
Do not fold the gasket.
If you do not use the appliance for a prolonged
period
1. Switch off the appliance.
2. Disconnect the appliance from the power supply.
3. Remove all food.
4. Defrost and clean the appliance.
5. Leave the doors open just enough to allow air
to circulate inside the compartments. This will
prevent the formation of mould and unpleasant
odours.
Troubleshooting
Problem
The control panel is switched
off and/or the appliance does
not work.
The inside light does not work.
Temperature inside the
compartments is not low
enough.
In the event of a power cut
•
•
Replacing the lighting
The appliance is equipped with a LED for interior
lighting.
Only an authorized technician is allowed to replace
the lighting device. Please contact your Authorised
Service Centre. For a quicker service, always refer to
the full list of Authorised Service Centres located at
the end of this manual and call the corresponding
phone numbers.
Possible causes
There may be a problem
with the power supply to the
appliance.
•
The light is broken.
•
Failure of a component
There could be various causes
(see the solutions in the next
column).
Note when the power cut starts and ends.
This helps you track how long the refrigerator has
been without power.
Keep the doors of the appliance closed. This will
allow the food to stay cold as long as possible.
Solutions
Ensure that:
•
There is no power cut.
•
The power plug is properly inserted
in the socket and the bipolar power
switch, if present, is set to the correct
position (on).
• The household electrical system
protection devices are in good working
order.
• The power supply cable is not
damaged.
•
Switch the appliance on with the
power button.
Refer to "Replacing the lighting"
Ensure that:
• The doors are closed properly.
• The appliance is not installed near a
heat source.
• The temperature is set appropriately.
• Air circulation inside the appliance
is not obstructed in any way
(see the installation instructions).
10