Gastroback EASY JUICER FUN Bedienungsanleitung Seite 44

Note:
Do not apply too much pressure onto the pusher, as this could decrease the quality
and amount of the juice and even cause the appliance to get blocked. The very
best method of processing is to drive the pusher slightly up and down repeatedly
until the feed chute is empty.
When the feed chute is empty, before processing the next portion, ensure that the
juice jug and pulp container can still absorb a sufficient amount of juice and pulp.
Do not fill the provided juice jug with more than 1000 ml (1 litre) to avoid
overflow. To empty the juice jug, simply take it out from under the juice out-
let. For this you may turn the protrusion on the drip-stop spout upwards to
avoid the spilling of juice. Ensure to turn the protrusion back down-
ward to open the drip-stop spout before juicing another portion of food.
To empty the pulp container, always switch OFF the appliance first (touch the ON/
OFF button twice until the ON/OFF button flashes), then unplug the appliance and
wait until the motor comes to a standstill. Disassemble the pulp container according to
the instructions in chapter 'Care and Cleaning' (see: 'Disassembling the Appliance').
After emptying juice jug and/or pulp container, ensure that you made the juicer
ready for use again (see: chapter 'Operation', section 'Assembling the Appliance'),
before switching it ON.
If desired, repeat this instructions with the next portion of food.
After extracting your food, wait for some seconds until no juice is flowing out of
the juice outlet any more. Then touch the ON/OFF button slightly to stop the motor.
Note:
The juicer is still in standby mode. The ON/OFF
ously and the right speed button
brake, touch the ON/OFF button again to switch OFF the appliance (ON/OFF
button flashes).
IMPORTANT: Do not leave the appliance unattended, when it is connected to the
power supply!
When you have finished juicing, wait until the filter basket comes to a complete
standstill. Then switch OFF the appliance by touching the ON/OFF button shortly
until the ON/OFF button flashes. Thereafter unplug the appliance.
Always switch OFF and wait until the filter basket comes to a com-
WARNING:
plete standstill, then unplug the appliance, when the appliance is not in use and
before opening the locking arms or moving or cleaning the appliance.
After each usage, clean the appliance according to the instructions in chapter 'Care
and Cleaning'.
44
button is illuminated continu-
is flashing. If you wish to make an elongated