Processing Your Food - Gastroback EASY JUICER FUN Bedienungsanleitung

Processing Your Food

Prepare the »Easy Juicer Fun« for operation as described in the section above. Pre-
pare your food (see: 'Tips for Best Results'). Remove all inedible parts and cut your
food in pieces of sufficient size (approx. 5-6 cm).
Ensure that a suitable juice container is placed under the juice outlet and the drip-
stop spout is in the open position.
Insert the power plug of the appliance in the wall power outlet. The ON/OFF button
will flash red.
Touch the ON/OFF button for approx. 5 seconds to switch ON the appliance.
The LCD screen will be activated, showing the already elapsed working time (00:00
on start-up). Additionally, the right speed button
Note:
The delay of 5 seconds for switching ON the appliance is intended as a child safe-
ty interlock to prevent little children from activating the appliance. If you touch the
ON/OFF button in standby mode again, the appliance will switch OFF.
Note:
For selecting an appropriate speed, see: 'Properties of Your New »Easy Juicer
Fun«'.
The motor will start agitating immediately, when you touch the right
IMPORTANT:
speed button . With the motor running, be aware that the appliance may move
around on the table or counter due to vibrations. Thus, ensure to keep the appliance
in an appropriate distance to the edge of the working space. After switching ON
the motor immediately fill in your food. You should NOT leave the motor operate
with empty feed chute for more than 1 minute.
Touch the right speed button
the LCD display and the working time display will start running. When touching the
right speed button
speed, touch the left speed button
of your new »Easy Juicer Fun«').
WARNING – Risk of Injuries:
ting on high speed at the bottom of the filter basket. Additionally, parts of your food
could splash out of the feed chute. Thus, during operation, DO NOT place your fin-
gers or any foreign objects into the feed chute. Do not hold your face over the feed
chute.
Take the pusher out of the feed chute and fill the prepared food into the feed chute.
However, at the maximum, fill the feed chute up to 2 cm beneath the brim, so you
can still insert the pusher. Use the pusher to push down the food only slightly.
to switch ON the motor. Speed 1 will be shown on
again, the speed will be increased in steps. To decrease the
. Select the appropriate speed (see: 'Properties
During operation, very sharp blades are agita-
starts flashing (standby mode).
43