Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11
Flash button
12
Fade Scene/Music fader
13
Fade Chase fader
14
Speed Chase fader
15
Master fader
16
Tap button
17
Store/Merge button
18
Overwrite button
19
Del(ete) button
20
Display and dial
The Flash button outputs all values of the stored lighting program for as
long as it is pressed. Once released, the values are also removed. This is
ideal for blinders, strobe functions or fog machines, for example.
This control is used to set the fade time between the steps (cues) of
scenes and music-controlled sequences. Alternatively, the fade time can
be set for each lighting program in the settings; the control then has no
function.
This control is used to set the fade time between the steps (cues) of
chases. Alternatively, the fade time can be set for each lighting program in
the settings; the control then has no function.
This control is used to set the running speed of chases. Alternatively, the
chase speed can be set using the tap button or specified in the settings.
The chase time is always set for all chases without a specified chase time,
regardless of whether they are currently active or not.
The master dimmer determines the overall brightness of all settings. All
channels defined as dimmers are dependent on the master dimmer; this
is not the case for function channels. For programming and normal
operation, the master dimmer should be at top position.
This button can be used to set a running time for chases by pressing it
twice. This works in the same way as if it had been set using the Speed
Chase fader.
Use this button to add a new step to a lighting program or edit an existing
step in programming mode. The exact procedure is explained in detail on
page 33.
Use this button to overwrite an existing step in programming mode. The
exact procedure is explained in detail on page 33.
Use this button to delete an existing step in programming mode. The
exact procedure is explained in detail in the light programming section. If
the DEL button is pressed for three seconds, all manual values (i.e. from
the upper faders) are set to 0.
Basic inputs and functions are controlled via the display and the dial. Use
the dial to make a setting, press Enter to confirm and ESC (escape) to go
back one step.
27 • EN
Werbung
