Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BSR -NC/NO SET-UP
BSR -NC/NO SET-UP
BSR - NC/NO SET-UP
In case of an electrical failure, the actuator which is fitted with the BSR plug-in failsafe system, will go to the prede-
termined position: NO (Normally Open) or NC (Normally Close).
Set up by using the SELDIR Jumper (Fig.9): NC: jumper on / NO: jumper off.
Set up by using the SELDIR Jumper (Fig.9): NC: jumper on / NO: jumper off.
Set up by using the SELDIR Jumper (Fig.9): NC: jumper on / NO: jumper off.
J4C 20 to 85
J4C 20 to 85
Fig. 9
Fig. 9
DPS
DPS
DPS
Use the configuration you need by moving the DIPs:
Place the DIPS (Fig. 10) according to the signal you need to work with.
Place the DIPS (Fig. 10) according to the signal you need to work with.
Place the DIPS (Fig. 10) according to the signal you need to work with.
External adjustment
External adjustment
External adjustment
B
C. plug - Connect a cable between PIN 1 (on the right side) and PIN Earth (on the bottom) (Fig. 11).
B
(Fig. 11).
(Fig. 11).
A. plug - Connect voltage to the actuator in the following way:
A. plug - Connect voltage to the actuator in the following way:
VAC: PIN1 (neutral) and PIN2 (phase).
A. plug - Connect voltage to the actuator in the following way:
VAC: PIN1 (neutral) and PIN2 (phase).
VDC: PIN1 (negative) and PIN2 (positive)
VAC: PIN1 (neutral) and PIN2 (phase).
NO (Normally Open) or NC (Normally Close).
NO (Normally Open) or NC (Normally Close).
Jumper SELDIR
Jumper SELDIR
4/20 mA
NC
4/20 mA
NO
(ENGLISH)
J4C 20 TO 300 INSTALLATION INSTRUCTIONS
J4C 140 to 300
J4C 140 to 300
Fig. 9
Fig. 9
0/10 V
NC
0/10 V
NO
BSR plug-in failsafe system,
BSR plug-in failsafe system,
Jumper SELDIR
Jumper SELDIR
Fig.10
Fig.10
1/10 V
NC
1/10 V
NO
INDEX
_
7
Werbung
