J+J J4C S20 Kurzanleitung Seite 25

BSR -NC/NO SET-UP
BSR: BSR: configurazione BSR NC - BSR NO
BSR -NC/NO SET-UP
Se l'unità dispone di un sistema BSR (max. 3 minuti), in mancanza di alimentazione elettrica l'attuatore si porta nella
posizione di default. "NO" normalmente aperto o "NC" normalmente chiuso. Configurare NO o NC con il Jumper SELDIR
Set up by using the SELDIR Jumper (Fig.9): NC: jumper on / NO: jumper off.
(Fig. 9):
· NC: jumper montato
Set up by using the SELDIR Jumper (Fig.9): NC: jumper on / NO: jumper off.
· NO: jumper non montato
J4C 20 to 85
J4C 20 to 85
Fig. 9
Fig. 9
DPS
DPS
DPS
Configurations possibles en fonction du signal analogique à travailler
Situer les DIPS (Fig.10) dans la position indiquée sur la partie inferieur, en fonction du
Place the DIPS (Fig. 10) according to the signal you need to work with.
signal à utiliser
Place the DIPS (Fig. 10) according to the signal you need to work with.
External adjustment
Auto-régulation externe
External adjustment
B
Connecteur centrale "C" = faire un croisement entre le COMMUTATEUR 1 (droite) et le COMMUTATEUR
B
TERRE (inférieur) (Fig.11)
(Fig. 11).
(Fig. 11).
Connecteur gris "A" = connecter la tension à l'actionneur :
A. plug - Connect voltage to the actuator in the following way:
A. plug - Connect voltage to the actuator in the following way:
VAC : COMMUTATEUR1 (neutre) et COMMUTATEUR2 (phase)
VAC: PIN1 (neutral) and PIN2 (phase).
VAC: PIN1 (neutral) and PIN2 (phase).
VDC : COMMUTATEUR1 (négative) et COMMUTATEUR2 (positive)
(ITALIANO)
NO (Normally Open) or NC (Normally Close).
NO (Normally Open) or NC (Normally Close).
Jumper SELDIR
Jumper SELDIR
4/20 mA
NC
4/20 mA
NO
ISTRUZIONI DI INSTALLAZIONE J4C DA 20 A 300
BSR plug-in failsafe system,
J4C 140 to 300
J4C 140 to 300
Fig. 9
Fig. 9
0/10 V
NC
0/10 V
NO
_
25
BSR plug-in failsafe system,
Jumper SELDIR
Jumper SELDIR
Fig.10
Fig.10
1/10 V
NC
1/10 V
NO
INDEX