TEUFELBERGER treeMOTION USCA Bedienungsanleitung Seite 4

GeneRaL
WARNING
This product is a work positioning belt
and sit harness, specifically designed
for arborists.
It must not be used to arrest a fall.
This product may be utilized only by
persons trained in its safe use and
having the relevant knowledge and
skills, or under the direct supervision
of such persons. Whenever possible,
the equipment should be provided per-
sonally to the user. It may be used only
within the specified limited scope of
use and for the defined purpose.
Prior to using this product, read this
document thoroughly, make sure you
understand the instructions for use,
and keep them with the product, to-
gether with the Inspection Sheet! Keep
instructions for future reference. In
addition, check national safety regu-
lations regarding personal protective
equipment (PPE) for arborists' use for
local requirements.
Attention! Consult AS/NZS 1891.4 for
guidance on selection, use and main-
tenance matters!
The product accompanied by this set
of instructions is type-examined and
CE-marked to state conformity with
WARNING
the use of our products can be dangerous. our products may only be used for their
intended purpose. they must particularly not be used for lifting as specified in eU
directive 2006/42/ec. the customer is responsible that the user has been trained
in the safe use of the product and in accompanying safety precautions.Be aware
of the fact that the product can cause damage if wrongly used, stored, cleaned
or overloaded.check national safety regulations, industry recommendations and
standards for local requirements. teUFeLBeRGeR
registered trademarks of the teUFeLBeRGeR Group.
4
the European directive 89/686/EEC
and regulation (EU) 2016/425 on Per-
sonal Protective Equipment (PPE). This
product has been developed according
to a risk analysis taking into account
the special requirements of arborists.
It deviates from the valid standards EN
358:1999 and EN 813:2008 in some
constructional details (especially width
of the ventrally used webbing). All fur-
ther constructional requirements are
fulfilled. All static test requirements of
the standards were met. Dynamic test
requirements of EN 358 were met, for
EN 813 the test dummy of EN 12277 was
used with additional weights. The total
test mass was 120 kg in all cases (test
dummy plus additional weights). The
treeMOTION USCA harness also com-
plies with AS/NZS 1891.1:2007. Testing
was performed with a test mass of 100
kg as given in the standard. Additionally,
the rope bridge attachment point was
tested dynamically with a test mass
of 120 kg. The product complies with
ANSI Z133-2017 for arboricultural op-
erations with ASTM F887-16 and with
CSA Z259.1-05. The product does not
comply with any other (ANSI) standards.
If the system is sold or passed on to
another user, the instructions for use
must accompany the equipment. If
and 拖飞宝
®
are internationally
®