TEUFELBERGER treeMOTION USCA Bedienungsanleitung Seite 11

2.6. ADJUSTMENT OF BUCKLES
The Cobra FX25 buckles of tree-
MOTION USCA are equipped with
an elastic cover that is easy to push
back. It is there to protect the buck-
le from dirt. Always push the cover
back sufficiently to check that the
buckle is securely closed. Listen for
two "click"-noises! Then put the cover
back in place. For information on how
to clean the buckle go to chapter 7.
3. MODES OF USE
There must not be any chance of a
free fall. „Free fall" does, however, not
mean e.g. slipping of the user´s feet.
Choose the connection of the harness
to an anchorage point at a level which
will result in the least total fall distance
consistent with the user's ability to
carry out work tasks.
When making any connection to a point
on a harness which cannot be seen by
the wearer of the harness, either make
it before putting the harness on, have
it made or checked for security by a
second person.
Use as Work Positioning Belt on the
basis of EN 358
Lateral
Feet
(e.g. Standing on pole with spikes).
Work positioning lanyard on a lev-
pic. 8
el with waistline when connected to
both standing D rings (4). (pic. 10)
For treeMOTION USCA only (not for
treeMOTION S.light USCA):
This is NO attachment point to ASTM
F887-16 and AS/NZS 1891.1:2007 sec-
tion 6.2.2 (b). Use as a restraint system
pic. 9
on working platforms. (The user must
not reach a point where a free fall is
possible.) Attach the work positioning
lanyard to the central rear attachment
ring (15). The anchor point must be
above waistline level. (pic. 11)
Use as Sit Harness on the basis of
EN 813:
– Suspended – central attachment on
rope bridge (10). Doubled (running)
rope system with friction hitch ad-
juster.
– Suspended – central attachment on
rope bridge (10). Single rope de-
scent with mechanical adjuster.
– Suspended – Attachment to both
front D rings (8). Doubled (running)
loading of the
should be well
pic. 10 pic. 11
Use
harness:
supported
11