Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safely rotate the handle
Use the correct process to eliminate the chance of pinching your thumb or rear-panel-connected cables while rotating the handle.
WARNING: Hold the top of the handle to rotate the handle on the instrument. Do not hold the handle from the sides and rotate, as
this can pinch the base of your thumb between the handle and the case.
CAUTION: If you have routed any cables between the handle and the case, be careful when rotating the handle so that you do
not pinch the cables.
Operating requirements
Use the instrument within the required operating temperature, power, altitude, and signal input voltage ranges to provide the most accurate
measurements and safe instrument operation.
Environment requirements
Characteristic
Operating temperature
Humidity
Operating altitude
Power requirements
Characteristic
Power source voltage
Power source frequency
Power consumption
Input signal requirements
Keep the input signals within allowed limits to ensure the most accurate measurements and prevent damage to the analog and digital
probes or instrument.
Make sure that input signals connected to the MSO instrument are within the following requirements.
4 Series B Mixed Signal Oscilloscopes MSO44B and MSO46B Quick Start Manual
Description
0 °C to +50 °C (+32 °F to +122 °F). For proper cooling, keep the sides of the instrument clear of
obstructions for 2 inches (51 mm).
Operating: 5% to 90% relative humidity (% RH) up to +40 °C (+104 °F), Noncondensing.
Non-operating: 5% to 50% RH above +40 °C up to +50 °C (+104 °F to +122 °F), Noncondensing.
Up to 3000 meters (9842 feet)
Description
100 V - 240 V
, ±10%, single phase
AC RMS
50/60 Hz, 100-240 V
400 W maximum
Preface
15
Werbung
