Installing Your Instrument; Check Shipped Accessories; Safely Rotate The Handle - Tektronix 5-Serie Schnellstart-Benutzerhandbuch

Installing your instrument

Check shipped accessories

Make sure that you received everything you ordered. If anything is missing, contact Tektronix Customer Support. In North America, call
1-800-833-9200. Worldwide, visit www.tek.com to find contacts in your area.
Check the packing list that came with your instrument to verify that you have received all standard accessories and ordered items. If you
purchased factory installed options such as a Serial Bus and Triggering option, or the Power measurements option, tap Help > About to
confirm that the options are listed in the Installed Options table.
Item
5 Series B MSO Installation and Safety Manual
TPP0500B Passive Voltage Probe (500 MHz bandwidth). Shipped with 350 MHz
and 500 MHz models.
TPP1000 Passive Voltage Probe (1 GHz bandwidth). Shipped with 1 GHz and 2
GHz models.
Front cover
Accessory pouch (attached to front cover)
Mouse (wired with USB connector)
Power cord
Calibration certificate
Report of factory installed licenses

Safely rotate the handle

Use the correct process to eliminate the chance of pinching your thumb or rear-panel-connected cables while rotating the handle.
Warning: Hold the top of the handle to rotate the handle on the instrument. Do not hold the handle from the sides and rotate, as
this can pinch the base of your thumb between the handle and the case.
CAUTION: If you have routed any cables between the handle and the case, be careful when rotating the handle so that you do
not pinch the cables.
5 Series B Mixed Signal Oscilloscopes MSO54B, MSO56B, MSO58B Quick Start Manual
Quantity Tektronix part number
1 071-3773-xx
One per channel TPP0500B
One per channel TPP1000
1 200-5406-xx
1 016-2106-xx
1 119-7054-xx
1 Depends on region
1 N/A
1 N/A
Installing your instrument
14