Jacuzzi Virtus Montageanweisung Seite 39

PROBLEM
The motor stops
The filter pump does not work
Abnormal operation of the spa
The display shows an unknown alphanu-
meric value
(models with heater)
The water temperature does not reach the
set value
*
: This type of repair requires the intervention of qualified personnel.
Contact your Jacuzzi® dealer or an authorised Service Centre.
It is the responsibility of the installer/owner to ascertain compliance with specific local regulations prior to installation. Jacuz-
zi Europe S.p.A. gives no guarantee in this respect and declines all responsibility regarding the compliance of the installation
performed.
Jacuzzi Europe S.p.A. © 2023
PROBABLE CAUSE
The function has ended
Overload
Power supply cables not suitable
No power
one of the causes of malfunction may be
incorrect setting of the B2 switch bench
(dipswitch no. 2)
Insufficient level of water in the tank (mes-
sage LL, L1 or L2 shows on the display)
Main switch has tripped
Circuit breaker has tripped
Faulty motor
Probable accidental pressing of a key
combination
Probable accidental pressing of a key
combination
The limitation of electricity consumption
is active (when the pump is switched on, the
heater switches off; the symbol
The fuses on the heater power line are
faulty
39
SOLUTION
Press the key
Let the motor cool, the problem should dis-
appear. If it persists, see *
Consult an electrician
Turn on the main switch
Refer to the "Electrical Connections and
Safety" section.
Add water to the hot tub until the message
on the display disappears
Turn on switch
Reset breaker
see note *
Refer to chap. "Control panel and functions"
- "Key combinations"
Refer to chap. "Control panel and functions"
- "Key combinations"
Refer to chap. respective
flashes)
see note: *
again
Jacuzzi Europe S.p.A. © 2023