Jacuzzi Virtus Montageanweisung Seite 37

- If present, remove the cover from the hot tub, so as to facilitate
cooling of the water.
- Add cold water to the hot tub if sunlight causes an excessive
increase in temperature.
When the temperature is within the allowed range, the pumps
can be activated again; if this does not happen, the fault could
be caused by a problem with the temperature probe: turn off the
power and contact an authorised Jacuzzi® Service Centre.
"HI" Excessive water temperature.
DO NOT ENTER THE WATER
The water temperature has reached or exceeded 42 °C (107.6 °F). It is
not possible to turn any function on.
- If present, remove the cover from the hot tub.
- Add cold water to the hot tub if sunlight causes an excessive
increase in temperature.
When the temperature has dropped to below 40°C (109°F), the
pumps can be activated again; if this does not happen, discon-
Troubleshooting (also refer to the chapter on abnormal operating conditions)
PROBLEM
Dirty water
Excessive water consumption
Low water flow from the hydromassage
nozzles
Jacuzzi Europe S.p.A. © 2023
nect the power supply and contact an authorised Jacuzzi® ser-
vice centre.
For all special maintenance work, we recommend contacting
an authorised Jacuzzi® service centre, providing the following
information:
- model;
- purchase date;
- serial number (shown on the warranty certificate).
Model _______________________________
Purchase date __________________________
Serial number __________________________
PROBABLE CAUSE
Filter clogged
Insufficient water treatment
High content of solid material in water
Manutenzione scorretta
Leak on delivery line, outlet line, connec-
tions
Excessive evaporation and/or water over-
flow
Low water level
Filter clogged
Adjustable jets partially closed
Suction or drain pipes partially clogged
Pump operates at a speed that is too low
Pump gaskets worn or damaged
Voltage too low
37
SOLUTION
Clean or replace filter
See chapter on water treatment
See the instructions regarding Maintenance
Repair the leak
Use the hot tub cover
Set a water temperature set point lower
Fill until covering the highest nozzles
Clean or replace filter
Open the jets
see note *
see note *
see note *
Contact an electrician or the electric power
utility
Jacuzzi Europe S.p.A. © 2023