Jacuzzi Virtus Montageanweisung Seite 32

A1
Notes:
- When first turned on, all of the numbers and LEDs on the control
panel will turn on. Following, the display will show the codes for the
firmware versions.
- In general, when the hot tub is filled for the first time, the water
temperature is lower than the factory set value (35°C), therefore the
heater and filtering pump
will show the temperature of the water in the tub).
The operation of the filtration pump is also signalled by the flow of
water coming out of the small jets on the hot tub wall.
- If the message "FLO/FLC"
the temperature value, the heater pressure switch/flow switch may
be faulty. Please see the "Abnormal operating conditions – alarm
signals" chapter.
Press the TEST button of the differential switch located up-
stream from the electrical system to which the hot tub is con-
nected. If it does not trip, it may be faulty or it may have tripped
due to problems in the electrical system of the building.
Disconnect the hot tub and do not use it until you have iden-
tified and eliminated the defect.
Check the operation of the pumps
- briefly press the "Pump"
1 on/off (the button briefly lights up blue, then returns to white);
- press the "Pump" button (display A2) to turn pump 2 on/off
(the button briefly lights up blue, then returns to white);
- press the "Pump" button once (display B) to turn on pump
Jacuzzi Europe S.p.A. © 2023
are activated (the control panel display
appears on the display, alternating with
and:
button (display A1) to turn pump
A2 A2
B
1; press it again to turn on pump 2. Press the button a third
time to turn off pump 1 and a fourth time to turn off pump 2.
Check that the spotlight switches on and off using the "Light"
key.
Check that there are no leaks from the hydraulic connections
or other problems.
Completely disinfect the hot tub by carrying out "super-chlo-
rination" treatment.
Please refer to the Jacuzzi system water treatment guide for
details on water quality maintenance, the methods and warn-
ings governing the use of relative chemical products.
ATTENTION!
PRECAUTIONS FOR THE USE OF PRODUCTS CONTAI-
NING SODIUM BROMIDE
Do not use any product containing sodium bromide
with a device that generates chlorine by electrolysis.
Do not use any product containing sodium bromide
with devices that produce ozone and/or generate
ultraviolet (UV) light.
After a few hours, turn off the omnipolar switch.
Open the drain valveand completely empty the hot tub.
If included, re-install the front and side panels.
CAUTION
Do not use the hot tub the first time you start it as there
is a high concentration of chlorine in the water during
this phase. Immediately empty the bath.
Contact the local authorities for the standards govern-
ing the discharge of chemically treated water.
32
pump
spotlight
viewing and adjusting temperature,
parameters, functions
filtering LED
heater LED
Temperature adjustment LED
Jacuzzi Europe S.p.A. © 2023
6