Maintenance And Care; Fuse Replacement; B) Cleaning - Renkforce 1490974 Bedienungsanleitung

Audio streaming
Audio streaming is the transmission of audio data (music) by Bluetooth
If you have am A2DP-capable mobile phone, you may connect it to the car radio by pairing as described above and
establish an audio transmission.
• Ensure that the two devices are connected by pairing.
• Start playback at your mobile phone (see corresponding operating instructions).
• Push the button MOD /
• The audio transmission is now active.
• You may now remote-control playback of your mobile phone with the buttons

11. Maintenance and Care

• Check the technical safety of the car radio regularly, e.g. for damage to the connection cables or to the casing.
• If it can be assumed that safe operation is no longer possible, the device must be turned off and precautions are to
be taken to ensure that it is not used unintentionally. Disconnect the car power system!
a) Fuse Replacement
• If it becomes necessary to replace a fuse, make sure that only fuses of the prescribed type and nominal current are
used (see "Technical Data").
Never repair fuses or bridge the fuse holder.
• When the power supply has been disconnected (disconnect ISO plug!) carefully remove the fuse from the fuse
holder next to the ISO plug.
• Replace it with a fuse of the same type.
• After this, you can reconnect the car radio to the board mains and take it into operation.
• Should the fuse trigger again, have the CD tuner repaired in a specialised workshop.

b) Cleaning

• Clean the exterior of the device with a soft, dry cloth or brush only.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solutions, since these may
damage the casing or even impair function.
54
(2) until BT AUDIO is shown in the display (4).
to the car radio.
®
(1), (7) and 1/ (13).