Parkside PAT 12 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 20

If the impact force is set correctly, the crown
of the staple or head of the nail is flush with
the fastened material.
˜ Clearing jammed staples/nails
m WARNING!
If a staple or nail is jammed, do not
pull the trigger
[ 3 ]
otherwise be triggered accidentally by the
product after removing the staples or nails.
Remove the battery pack
product before clearing the jammed
staples or nails.
Open the magazine
rod from the product.
9 ] [
Remove the jammed staples/nails from the
magazine .
[ 8 ]
˜ Checking the battery level
(Fig. G)
Press down the safety contact
surface. The remaining energy level is shown
on the LEDs of the battery level indicator
LEDs
Red
Red and orange
Red, orange and green
NOTE
When the battery level is below 30 %:
u
Charge the battery pack
18 GB
! Staples or nails may
from the
[ 5 ]
by pulling the push
[ 8 ]
onto a hard
[ ]
2 ] [
Battery level
below 30 %
30–70 %
above 70 %
.
5 ] [
˜ Belt clip
The belt clip allows the product to be hooked
[ 6 ]
on a belt or pocket.
˜ Cleaning and care
m WARNING!
Remove the battery pack
let the product cool down before
performing inspection, maintenance
and cleaning work!
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease. Remove debris
from the product after each use and before
storage.
.
Regular and proper cleaning will help ensure
safe use and prolong the life of the product.
Clean the product with a dry cloth. Use a soft
brush for areas that are hard to reach.
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces.
and
5 ] [