Parkside PAT 12 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 18

˜ Before first use
˜ Accessories
Only use the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
product.
Accessories and accessory tools are available
through your authorised dealer. When buying
always consider the technical requirements of
this product (see "Technical data").
If you are not certain, ask a qualified
specialist and get advice from your trusted
dealer.
m WARNING!
Do not use accessories not recommended
u
by Parkside. This may result in electric shock
or fire.
˜ Charging the battery pack
(Fig. H)
m CAUTION!
Always disconnect the power plug
u
before removing the battery pack
the charger and before connecting it to
[ ]
the charger.
NOTE
Our battery packs
u
charged. Charge the battery pack
completely before first use.
The battery pack
u
any time as needed without shortening its
service life.
Interrupting the charging process does not
u
damage the battery pack
Never charge the battery pack
u
ambient temperature is below +10 °C or
above +40 °C.
Insert the battery pack
charger .
[ ]
Connect the power plug
socket-outlet.
16 GB
[ ]
from
5 ] [
are partially
5 ] [
can be charged at
[ 5 ]
.
5 ] [
if the
5 ] [
into the
[ 5 ]
to a suitable
[ ]
The charging control LEDs (green
red ) indicate the charging status of the
[ ]
battery pack :
[ 5 ]
LED Status
Red LED lights up Battery pack is charging
Green LED lights up Battery pack fully charged
When the battery pack is fully charged:
Disconnect the power plug
socket-outlet.
Remove the battery pack
charger .
[ ]
˜ Inserting the battery pack
into the product
(Fig. E)
Align the ribs of the battery pack
[ ]
the battery compartment's slots.
Slide the battery pack
the battery compartment until the battery
latches lock with an audible click into the
4 ] [
battery compartment.
˜ Removing the battery pack
from the product
(Fig. F)
Press and hold the battery latches
Pull the battery pack
compartment.
˜ Preparation
m WARNING!
Always remove the battery pack
before filling in or changing nails or
staples.
˜ Choosing the correct length
for nails and staples
Consider 2 factors to choose the correct
length for staples and nails:
– the thickness of the material to be fastened
– the composition and hardness of the base
material
and
[ ]
from the
[ ]
from the
5 ] [
with
5 ] [
completely into
[ 5 ]
.
4 ] [
out of the battery
[ 5 ]
5 ] [