General Notes - WimTec PROOF W6 Montageanleitung Und Bedienungsanleitung

EN
PROOF W6

General notes

The "General installation
terms and conditions"
provided at
www.wimtec.com apply.
18 Wall tap control
Congratulations on purchasing the WimTec PROOF W6.
In order to ensure that you will be able to enjoy this high-quality
product for many years, please take note of the following cleaning
and maintenance recommendations:
Use mild cleaning agents containing soap
Do not use abrasive, scrubbing, sealing or acidic
cleaning agents or disinfectants
Clean the fitting with a soft sponge or cloth only
Do not use steam cleaners
This manual is valid for the following products:
WimTec PROOF W6 wall tap control:
Art.Nr. 118 728, 118 735, 118 766, 118 773
WimTec PROOF W6 wall tap control with thermal disinfection:
Art.Nr. 118 742, 118 759, 118 780, 118 797
Delivery scope:
Front plate made out of staineless steel or chomed brass, mounting
frame with integrated electronics, outlet and thermostat handle
with hot-water barrier.
Important installation notes:
Mounting and installation may only be performed by a qualified
service provider in accordance with DIN 1988, ÖVE/ÖNORM E8001
and VDE 0100 Part 701. When planning and installing sanitary
facilities, all relevant local, national and inter-national standards
and provisions must be observed! Provide for 230 V / 12 V power
unit outside of the protected zone.
!
According to the Austrian ÖNORM B 5019, thermal disinfection re-
quires a minimum temperature of 60 °C for at least 10 min at the
relevant system locations. The operator must ensure that all parts
of the installation (e.g., piping) can withstand the temperatures
applied during thermal disinfection.
WimTec OCEAN W6