Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PROOF S4
General notes
The "General installation
terms and conditions"
provided at
www.wimtec.com apply.
Congratulations on purchasing the WimTec PROOF S4.
In order to ensure that you will be able to enjoy this high-quality
product for many years, please take note of the following cleaning
and maintenance recommendations:
Use mild cleaning agents containing soap
Do not use abrasive, scrubbing, sealing or acidic
cleaning agents or disinfectants
Clean the fitting with a soft sponge or cloth only
Do not use steam cleaners
This manual is valid for the following products:
WimTec PROOF S4 - 12 V
Stainless steel
Chrome
Delivery scope:
Front plate made out of staineless steel or chomed brass with
integrated electronics, mounting frame and thermostat knob with
hot-water barrier.
Important installation notes:
Mounting and installation may only be performed by a qualified
service provider in accordance with DIN 1988, ÖVE/ÖNORM E8001
and VDE 0100 Part 701. When planning and installing sanitary
facilities, all relevant local, national and inter-national standards
and provisions must be observed! Provide for 230 V / 12 V power
unit outside of the protected zone.
!
According to the Austrian ÖNORM B 5019, thermal disinfection re-
quires a minimum temperature of 60 °C for at least 10 min at the
relevant system locations. The operator must ensure that all parts
of the installation (e.g., piping) can withstand the temperatures
applied during thermal disinfection.
WimTec PROOF S4
Shower control
EN
Art.Nr. 119 718
Art.Nr. 119 701
11
Werbung
Inhaltsverzeichnis
