WimTec PROOF W6 Montageanleitung Und Bedienungsanleitung Seite 25

PROOF W6
Assembly
12
15
12. Correctly align the mounting frame.
Apply the included special grease to the front of the valve.
13.
Connect the mounting frame sensor cable to the electronics
module.
14. Configure the desired functions at the electronics module,
and insert the module into the flush-mount kit.
15. Check the thermostat position – the arrow should be
pointing upwards.
16. Check the position of the thermostat knob – the locking
knob should be pointing directly upwards.
17.
Insert the front plate at an angle, and apply some pressure
while turning it until it is aligned horizontally.
13
16
Wall tap control
14
17
ATTENTION!
Perform the following steps
in the order indicated!
WimTec OCEAN W6
EN
!
25