Werbung
or twice if the display shows other parameters, either
before starting the pump or after it is operating.
If LOW SPEED is selected before starting the pump,
the display shows:
R E A D Y
F O R
S O F T
S T A R T
The pump reaches the Normal high speed, then
decrease the speed to the low speed value and the
display shows:
A P P R O A C H
X X
If the Soft Start has been deselected the display shows:
P U M P
R E A D Y
S T A R T
where: LS = means low speed mode is selected.
After starting, a LS appears on the right bottom corner
of the following displays:
S O F T
S T A R T
[
-
-
-
-
P U M P
I
S
1 2
X X
N O R M A L
X X
and when the pump reaches the low speed value, display
reverts to:
N O R M A L
2 8
L O C A L
L S
I
N G
L S
K R P M
L S
:
P U S H
B U T T O N
L S
O N
-
-
-
-
-
-
]
L S
S T A R T
I
N G
K R P M
L S
O P E R A T
I O N
K R P M
L S
O P E R A T
I O N
K R P M
L S
With normal LOW SPEED operation, the pump will run
at about 2/3 of its nominal speed and achieves a base
pressure
somewhat
specifications. If the gas load becomes higher, the
controller output frequency and voltage start to
decrease automatically, and the Turbo-V pump is
slowed down in proportion to the gas load until it
reaches about 3 KRPM.
If the LOW SPEED mode is selected after normal
operating condition is reached, the display shows:
A P P R O A C H
X X
while approaching the low speed value.
When the low speed mode is deselected the pump
starts to accelerate to its rotational speed. When this is
reached, the display shows:
N O R M A L
X X
90
TECHNICAL INFORMATION
higher
than
the
standard
I
N G
L S
K R P M
O P E R A T
I O N
K R P M
87-900-885-01 (D)
L S
Werbung
