Trouble-Shooting; Technical Data; Central Unit; Hand Transmitter - Waeco MagicSafe MS650 Montageanleitung Und Bedienungsanleitung

MS-650.qxd 13/08/03
The range of my hand transmitter becomes
shorter
I have lost/damaged my hand transmitter?
I get 3 signal tones/flashes when I activate the
alarm system instead of the usual message?
I get 4 signal tones/flashes when I deactivate the
alarm system instead of the usual two
messages?
I have deactivated the alarm system several
minutes ago, but now is the system reactivated?

Central unit

Operating voltage
Current consumption
Operating temperature :
Dimensions

Hand transmitter

Transmission frequency:
Encoding
Operating voltage
Range
Battery type
Operating temperature :
Dimensions
12:58 Page 63

Trouble-shooting

The transmitter battery is running flat?
You can deactivate the system using the
override-mode and your PIN-code
The system is warning you (a door or bonnet is
open instead). Deactivate the system, correct the
problem and try again.
The system has set off an alarm- check the
alarm display of the system via the LED (number
of the flashing symbols), thereby you determine
the sensor which has caused the alarm.
It is possible that the alarm system detected that
you have not entered the vehicle and thus it has
reactivated and has locked the doors if this soft-
ware option was selected (program setting).
Leave a door, the boot or bonnet open to avoid
this.

Technical data

: 12 volts DC
: < 20mA (activated) <7mA (deactivated)
-20°C - +75°C
: (W x H x D) 123 x 34 x 99 mm
433,992MHz
: Alternating code system
: 3 volts
: up to 20m
: CR2032
-20°C - 75°C
: (W x H x D) 36 x 13 x 52 mm
63