Tools Required; Introduction - Waeco MagicSafe MS650 Montageanleitung Und Bedienungsanleitung

MS-650.qxd 13/08/03
The following are required for the installation:
measure (see ✎ A 5)
–
prick punch (see ✎ A 6)
–
hammer (see ✎ A 7)
–
drill bits (see ✎ A 8)
–
drill (see ✎ A 9)
–
screwdrivers (see ✎ A 10)
–
The following are required for the electrical connections and testing:
diode test-lamp or voltmeter (see ✎ A 1)
–
crimping pliers (see ✎ A 12)
–
– insulation tape
– heat-shrinking tubing
hot-air blow-drier (see ✎ A 11)
–
Soldering iron (see ✎ A 13)
–
solder (see ✎ A 14)
–
For securing the receiver and cables, you may also need bolts, metal
screws and cable binders.
The magic safe MS-650 alarm system offers many advanced features,
some of which may be dependent on the systems already available in
your vehicle. Some features are designed as options and have to be
possibly configurated or programmed during the installation. The system
is designed for vehicles with an on-board voltage of 12 volts.
The magic safe MS-650 is a microprocessor-controlled alarm system
designed to help protect vehicles and their contents from being stolen.
When activated, the alarm system will trigger if a door, a boot, a bonnet is
opened, the ignition is turned on or movement is detected by the sensors
in the interior of the vehicle.
The alarm protects the vehicle by sounding the car horn (or optionally a
siren) and flashing the indicators for 30 seconds.
Important note! The pin code set by the factory is 11!
12:58 Page 42
Necessary tool

Introduction

42