Waeco MagicSafe MS650 Montageanleitung Und Bedienungsanleitung Seite 44

MS-650.qxd 13/08/03 12:58 Page 44
Selection of the locations (see ✎ B 9)
3. Ultrasonic Electronics Module
Mount the ultrasonic electronics module in a suitable location somewhere
near the MS-650 ECU, using either the screws provided in the kit or the
double-sided pad. Route the sensor leads down the A-pillars and across
the dashboard to the ultrasonic electronics module. Connect the sensor
to the ultrasonic-module and the module to the control unit with the
appropriate cables (see ✎ C 1)
4. Status-LED
Drill an 8 mm hole in the dashboard for the status-LED or if possible in an
existing plastic covering. Route the cable to the ECU and connect it to
the two-pole connector on the ECU.
5. Access switch
The access switch should be mounted in the dashboard within easy reach
of the driver when he is sitting in the driver's seat. This switch will not be
required during normal operation and we recommend that it is mounted
on the underside of the dashboard in a location where it cannot be hit
against when the driver is getting into and out of the vehicle. Drill a 7 mm
hole and fasten the switch using the locking nut provided. Route the
wiring to the ECU. There the dipole plug is plugged into the socket
provided there.
6. Bonnet-pin switch
Install the bonnet – pin switch in case there is no original one for the bon-
net. Drill an 8 mm hole. Take care that the distance to the closed
bonnet is minimum 22 mm and maximum 27 mm (e.g. measure by using
masticated modelling clay).
The minimum distance can be reduced by shortening the switch.
After installation, please check the switching functions properly.
44