Software Adjustments - Waeco MagicSafe MS650 Montageanleitung Und Bedienungsanleitung

MS-650.qxd 13/08/03
The magic safe MS-650 has a number of software selectable features
These can be changed using the procedure listed below. Some of these
features are to enable the alarm system to be configured to the vehicle
e.g. other switch settings will be determined by customer preference.
Therefore, you should discuss these requirements with the customer
before the vehicle is supplied. Please see the selection list specified
below which gives details of the possible software adjustments. For
programming see Programming.
Software switching function
Button
1-1 Self-activation ON/OFF
1-2 Alarm duration (30 or 60 sec.)
1-3 Lock with reactivating
1-4 Locking / unlocking via the
ignition
1-5 Acknowledging tone via siren ON/OFF
1-6 Duration of impulse of the door locking
function
2-1 Convenience output active
2-2 Duration of impulse of the convenience
output
2-3 Alarm delay time after
self-activation
2-4 Delay time for alarm triggering
2-5 Siren / horn selection
2-6 Reactivate
3-1 PIN Access 11-99 Digit Code
3-2 Deletion of the programmed hand
transmitters. The last hand transmit-
ter used remains in operation.
3-3 Setting the work's adjustment
* The default pin code set by the factory is 11.
12:58 Page 58

Software adjustments

Works'
adjustment
OFF
30 sec.
OFF
ON
ON
0,6 sec.
ON
10 sec.
YES
10 sec.
horn
On
1&1*
-
-
58 58
Blue button Grey
ON OFF
30 sec. 60 sec.
ON OFF
ON OFF
ON OFF
0,6 sec. 3,5 sec.
ON OFF
10 sec. 25 sec.
YES NO
10 sec. 20 sec.
siren horn
On Off
1-9 1-9
Activate both at Activate both at
the same time the same time
Activate both at Activate both at
the same time the same time