Parkside PSSSA 20-Li B2 Originalbetriebsanleitung Seite 32

GB MT
•­ Fine­and­clean­cutting­edges­can­be­
achieved­with­no­pendulum­stroke­
motion­(level­1).
•­ For­thin­material,­hard­material­
(e.g.­steel)­and­for­cutting­curves,­use­
level­1­also.
•­ Soft­material­(wood,­plastic,­etc.):­Set­
the­pendulum­stroke­switch­to­level­2.
­ With­the­pendulum­stroke­activated­
you can work much faster.
Plunge cuts
Plunge­cuts­may­only­be­made­in­soft­ma-
terials such as wood, aerated concrete,
plasterboard,­etc.­However,­this­requires­a­
certain amount of practice and is possible
only with short saw blades.
1.­ Place­the­saw­on­the­workpiece­and­
switch it on.
2.­ Make­sure­that­the­front­edge­of­the­
support plate rests on the surface of the
workpiece.
3. Slowly saw at an angle into the work-
piece, then bring the saw blade into a
vertical­position.
4. Continue sawing along the cutting line.
5. Turn off the saw and lift it off the work-
piece­after­finishing­work.
Sawing with the
cordless sabre saw
1.­ Turn­on­the­device.­Before­switching­
the­device­on,­ensure­it­is­not­in­contact­
with the workpiece.
2.­ Place­the­support­plate­(6)­on­the­work-
piece.
3. Cut with a uniform forward motion.
You can saw horizontally, diagonally
or­vertically.
32
4.­ After­finishing­your­work,­first­remove­
the saw blade (11/12) from the saw
cut­and­then­switch­the­device­off.
Working instructions
­ Wear­protective­gloves­when­hand-
ling the saw blade. In this way, you
avoid­injury­from­cuts.
•­ Clamp­the­workpiece.­Use­a­clamping­
device­for­small­workpieces.
•­ Draw­a­line­to­specify­the­direction­in­
which the saw blade is guided.
•­ Hold­the­device­securely­by­the­handle.
•­ Set­the­pendulum­stroke­on­or­off.
•­ Turn­on­the­device.
•­ Wait­until­the­device­has­reached­full­
speed.
•­ Place­the­support­plate­(6)­on­the­work-
piece.
•­ Do­not­apply­too­much­pressure.­Move­
the­device­slowly.­Let­the­device­do­the­
work.
Excessive­pressure­may­bend­and­
break the saw blade.
•­ Before­shutting­down­the­device,­switch­
it off and wait for it to come to a com-
plete standstill.
Cleaning­and­Servicing
Switch off the device and re-
move the battery before car-
rying out any maintenance
work.
­ Always­wear­protective­gloves­
when handling the saw blade in
order­to­avoid­cutting­yourself.
­ You­should­have­any­repair­and­
maintenance work that is not de-
scribed in these instructions carried