Herunterladen Diese Seite drucken

Kärcher SC 1475 Kurzanleitung Seite 24

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Power nozzle (D4)
The power nozzle is attached directly or
using the extension piece (D2) on the detail
nozzle. The power nozzle increases the
emission speed of the steam.
Application:
– removal of especially stubborn dirt
– cleaning out corners, joints, etc.
Manual nozzle (E1)
Pull the terry cloth cover (E2) over the manu-
al nozzle.
Application:
– small, washable surfaces, such as kit-
chen surfaces made of plastic, tiled walls
– windows, mirrors
– furniture fabrics
– vehicle interior, windscreens
– bath-tubs
Window nozzle (F1)
Application:
– windows
– mirrors
– glass surfaces on shower cubicles
– other glass surfaces
Apply steam to the glass surface from a
distance of approximately 20 cm until the
surface is moistened evenly. Then push
the lock (C3) to the rear to prevent an un-
desired actuation of the steam switch
(C4). Wipe the glass surface in straight li-
nes from the top to the bottom using the
rubber lip of the window nozzle. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
Before cleaning with the window nozzle,
disolve fat residue using the manual
nozzle (E1) and a terry cloth cover (E2) .
Floor nozzle (H1)
Application:
– all washable wall and floor coverings,
e.g.: stone floors, tiles, and PVC floors.
Attach the floor cloth to the floor nozzle.
24
English
1 Fold the floor cloth the long way and pla-
ce the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
To remove the cloth, press the retaining
clips (H2), and pull out the cloth.
Turn and exchange the floorcloth in re-
gular intervals. Thus, you improve the
ability to pick up dirt.
Work slowly on very dirty surfaces to al-
low the steam to act on the dirt for a lon-
ger period of time.
If there are residues of detergents or
floor cleaning products (e.g. wax, liquid
polish) on the surface to be cleaned, st-
reaks may form during the cleaning. The-
se streaks normally disappear after a
repeated use of the steam cleaner.
Steam turbo-brush (I1)
The steam turbo-brush is rotated by the
emitted steam and is ideally suited for the
easy cleaning of extreme dirt at places in the
kitchen and the bathroom that are difficult to
access.
Application:
– cleaning of corners, joints
– areas that are difficult to access
Warning
Long hours of using the appliance can cause
circulation problems in the hands on account
of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sever-
al factors:
Figure 10

Werbung

loading