Kärcher SC 1475 Kurzanleitung Seite 20

Preparing the Appliance
Unpacking the Appliance
When you unpack the system, check that
everything is complete (see page 3). If there
are any missing parts or you detect any
transport damage when unpacking, please
inform your dealer immediately.
The packaging materials are
recyclable. Please do not throw
packaging in the domestic wa-
ste but pass it on for recycling.
Old units contain valuable re-
cyclable materials. Batteries,
oil and similar substances may
not be released into the envi-
ronment. Therefore please dis-
pose of old units through
suitable collection systems.
Storing the Accessories
Place the manual nozzle (E1) into the
appropriate accessory compartment
(see Fig. 1).
Note: The detail nozzle (D1), the exten-
sion piece (D2), the round brush (D3),
and the power nozzle (D4) are already
stored.
Hold the unlocking button down, and
push the parking device (G3) on an ex-
tension tube (G1) until it locks into place
in the second aperture. The parking de-
vice must lock into place when you re-
lease the unlocking button (see Fig. 2).
20
English
Put the floor nozzle (H1) on the extensi-
on piece with the parking device.
Insert the window nozzle (F1) on the se-
cond extension piece.
Put the extension pieces into the large
accessory compartments (see Fig. 3).
Putting Down the Accessories
If you interrupt your work for a short period of
time, the extension tube with the floor nozzle
can be put into the parking position (see
Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4