Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.4. Further maintenance recommendations
EN
6.4.1. Spindle jacks
The operator sets appropriate inspection intervals according to the frequency of use and the operating conditions.
Regular cleaning is required. Do not use steam jets!
A general overhaul must be carried out by the manufacturer after 10 years at the latest.
ATTENTION
Injury to persons and damage to property
Improper maintenance of the product may result in injury to persons or damage to property.
Maintenance and inspection intervals:
Apply more lubricant (to grease nipples), taking care to fully extend and retract along the
Check the spindle jacks and nuts for signs of wear. Replace and lubricate if necessary.
Recommended lubricants:
Multi-purpose grease according to DIN 51502
Gears: K 3 K-20; spindle jacks: KP 2 K-30
60
All loads must be removed from lifting equipment before any inspection, maintenance or repair work is
carried out.
Have all work on brakes and locks carried out exclusively by qualified, specially trained personnel.
Visual and functional check
Brake function under load
entire stroke
Check that the type plate is legible
Professional inspection
Check gear components. Replace and lubricate if necessary.
before each use
before each use
every six months
annually
annually
annually
once every 2 to 5 years
Werbung
