Beko EB 9/41 FHL Gebrauchsanleitung Seite 18

Timer provides following features: Touch control
can command to maximum 4 cooking zone
timers and one alarm cooking timer assigned at
the same time. All timers can only be used in
operation mode.
Timer as an alarm
Alarm timer operates independently from
other cooking zones. Therefore, it is not
important whether a cooking zone is selected
or not.
1. Touch "©" key to enable the alarm timer.
"00" and "=2) 2s" will appear on the timer
display and a dot will appear on the lower
right side. Thus, alarm timer is activated.
2. Then, set the desired time value by touching
"A" and "W" keys.
3. Timer will start to countdown after you have
made the time setting.
» When the time is over, an audible alarm will
sound. Touch any key on the touch control panel
to silence the audible alarm.
Cooking zone timer:
The cooking zone timers cay only be set for
the cooking zones that are activated.
1. First turn on the hob and then enable the
desired cooking zone. (cooking zone must be
set to a value between 1 and 9)
2. Asinthe alarm timer, enable the cooking
zone timer by touching "©" key. "00" and
RO W
dot will appear on the lower right side. Thus,
cooking zone timer is activated.
3. You must touch "©" key for a second time in
order to enable cooking zone timer. Now you
can assign the timer.
18/EN
4, Set the desired time value by touching "A"
and "7" keys.
To set the hob timers:
1. After enabling the first cooking zone timer,
touch the "©" key again. The control will
turn clockwise towards the next active
cooking zone assigned to the timer.
Assignment proposal will be shown with a
flashing "el" LED.
2. Set the desired time value by touching "A"
and "y" keys.
3. Timer activated for the cooking zone which
was set first is indicated with a continuously
flashing "el" LED.
e More timers can be assigned for other
active cooking zones by touching the "©"
key once again.
e After 10 seconds, timer display reverts back
to the timer that will end first.
prep eee
the timer display indicate the timer that is
currently counting down.
e You can display the values set for cooking
zone timers and egg timer by changing the
position of "©" key. A flashing front right
"el" LED always shows an assignment.
If no LED is flashing, value of the egg timer
will be displayed on the timer screen.
Disabling the timers:
First you must display the timer by changing the
position of the "©" key until the timer appears.
This value can later be cancelled in 2 different
ways:
e By decreasing the value step by step to
"00" by touching "y" key.
e = By touching "A" and "<7" keys
simultaneously for half second until "00"
appears on timer display.
When the time is over, an audible alarm will
sound. Touch any key on the touch control panel
to silence the audible alarm.