Beko EB 9/41 FHL Gebrauchsanleitung Seite 19

y
zone timer 3 (indicator LED flashes) to the timer
display (the indicator LEDs of the active timers of
the cooking zones 1 and 4 in fact will not be
visible on the timer display).
Keep warm function (if any)
Keep Warm function of the cooking zone helps to
keep the food warm by selecting an additional
temperature level between 0 and 1. Touch")
key to activate the Keep Warm function.
Then, "O" LED flashes. Touch "O" key again to
disable the cooking zone.
Operation time constraints
The hob control is equipped with an operation
time limit. When one or more cooking Zones are
left on unintentionally, the cooking Zone will
y
period of time. (see, Table-1). Operation time
limit depends on the selected temperature
setting. If there is a timer assigned for the
cooking zone, "00" appears on the timer display
for 10 seconds (10 seconds later, residual heat
indicator turns on).
Then, timer display is turned off.
After disabling the cooking zone automatically as
described above, it becomes operational again
and maximum operation time is applied for this
temperature setting.
Table-1: Temperature setting parameters; Cycle time 47.0 seconds
Operation time
limit - hour
Residual Heat Functions
For a deactivated cooking zone whose surface
temperature is sensed to be above 60°C or
whose display indicates a value above 60°C, a
hl" (residual heat) symbol appears on the
display. When residual heat falls below 60°C,
"0" appears on the display.
When power restores after a power failure and if
the residual heat of the relevant cooking zone
was above 60°C before the failure, residual heat
display flashes. Display continues to flash until
the maximum residual heat time is over or the
cooking zone is selected and enabled.
Sensor Calibration and Error Messages
When the supply power is applied, hob control
System performs calibration depending on the
sensor, glass and ambient conditions. Do not
cover the glass part of the sensor with anything
19/EN