Beko EB 9/41 FHL Gebrauchsanleitung Seite 20

during calibration. Hob control system should
also not be exposed to strong light sources such
as Sun light, strong halogen lamps and etc.
Table-2:Error codes and error sources
Sample application:
Following lightning conditions will allow a
smooth calibration:
Illumination with a bulb without a reflector (100W,
dull) 70 cm above the glass ceramic hob. After a
successful calibration, it is warranted that the
hob will operate as intended even under a strong
illumination such as halogen spot lamp wit
reflector (50 W).
IF an error occurs, calibration is repeated until the
ambient conditions allow for a successful
calibration. Hob control system can only be
20/EN
operated when the calibration of all sensors are
successful.
You must remove all substances on the hob
during calibration. Also the ambient illumination
should not be too strong during calibration. If one
of the F1, F2 or F4 messages is obtained, user
must turn off all light sources or close the
window during the calibration process at first
connection to the supply power. When the
calibration is completed successfully, control
system can tolerate high amount of ambient light.
Hob control system adopts and recalibrates itself
according to the changes in ambient conditions
while it is in use.
æ | ouch control is equipped with a sensor
ensuring protection against overheating.
Relevant cooking zone will be deactivated
when reacting to this sensor. To obtain
more information about the error messages,
please see the table.
IF a key is activated repeatedly (for longer
than 10 seconds), all control system is
deactivated and audio signal is given.