Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing the product
aking connections to different holes is not
1. The sealing gasket provided in the package
a good practice in terms of safety since it
must be applied on the lower casing bend
can damage the gas and electrical system.
around the hob as shown in the figure,
during installation of the hob
Final check
1. Plug in the power cable and switch on the
product's fuse.
2. Check the functions.
Future Transportation
e
Keep the product's original carton and
transport the product in it. Follow the
instructions on the carton. If you do not
have the original carton, pack the product in
bubble wrap or thick cardboard and tape it
securely.
Check the general appearance of your
2. Place the hob on the counter and align it.
3. Using the installation clamps secure the hob
by fitting through the holes on the lower
{product for any damages that might have
occurred during transportation.
ü
min. 20 & max. 40 mm
#
min. 50 mm
1
Hob
2
Screw
3
Installation clamp
4
Counter
5
Sealing gasket
6
Separator plate
Rear view (connection holes)
11/EN
Werbung
