Panasonic WJ-AVE5 Betriebsanleitung Seite 8

20.
21.
Title
Superimposed Picture
22.
23.
24.
25.
26.
27.
28.
29.
B-bus Paint ON/OFF Switch (PAINT)-B
This switch is used to obtain an oil-paint touch effect
for the B-bus picture. Pressing this switch once, an oil
paint touch effect is applied to the B-bus image and
the LED indicator in the switch lights. The graduation
of paint effect can be changed in 4 steps (1 bit to 4
bits). To return to a normal picture, press the switch
once more. The LED indicator goes off.
Reverse Switch (REVERSE)
This switch is used to select the polarity of the
superimposed key signal.
Original Picture
Superimpose ON/OFF Switch (ON)
This is the master ON/OFF switch for the superimpose
function.
When the superimpose effect is selected,
the superimpose effect is not performed in
the left and top edges. It does not indicate
equipment failure.
External Camera Selection Switch (EXT CAMERA)
This switch is used to select a external camera as a
key signal for the Superimpose Effect.
A-bus Selection Switch (A)
This switch is used to select a A-bus picture as a key
signal for the Superimpose Effect.
B-bus Selection Switch (B)
This switch is used to select a B-bus picture as a key
signal for the Superimpose Effect.
Audio Level Indicator (AUDIO LEVEL)
These LED indicators show the output fevel for the left
and right channels respectively.
Back Colour Switch (BACK COLOUR)
This switch is used to select the colour of the
superimposed titles chosen by the Back Colour
Selection Switch (5).
White Colour Switch (WHITE)
This switch is used to select the colour of the
superimposed titles as a white colour.
Title Effect Switch (TITLE EFFECT)
By depressing this switch, the superimposed titles can
be changed as follows:
Becomes the colour of title
Original Picture in the title
[
Normal — Narrow Border — Wide Border —
— Narrow Shadow — Wide Shadow — Drop Shadow =
Normal
Narrow Shadow
30.
31.
32.
33.
34.
35.
36.
37.
38.
Narrow Border Wide Border
[A> [\» [Ao
Wide Shadow Drop Shadow
"As \* A
Key Level Control (KEY LEVEL)
This control is used to adjust the luminance level of the
key signal.
A-bus Recording Video Output Selection Switch
(REC VIDEO OUT/A)
This switch is used to select the A-bus picture as for
the Recording Video Output signal. The LED lights up
when this switch is selected.
B-bus Recording Video Output Selection Switch
(REC VIDEO OUT/B)
This switch is used to select the B-bus picture as for
the Recording Video Output signal. The LED lights up
when this switch is selected.
Effect Recording Video Output Selection Switch
(REC VIDEO OUT/EFFECT) :
This switch is used to select the effected signal
(Superimpose, Mix/Wipe or Fade) as for the Recording
Video Output signal, The LED lights up when this switch
is selected.
Colour Selection Switch (BACK COLOUR)
This switch is used to select the colour for the fade-out
mode. The colour is set by the Back Colour Selection
Switch (5). The LED lights up when this switch is
selected.
Colour Selection Switch (WHITE)
This switch is used to select a white colour when the
picture fades out in white. The LED lights up when this
switch is selected.
Colour Selection Switch (BLACK)
This Switch is used to select a black colour when the
picture fades out in black. The LED lights up when this
switch is selected.
Video Fade Switch (VIDEO)
When this switch is selected, the picture will be faded
inor out. The LED lights up when this switch is selected.
Title Fade Switch (TITLE)
When this switch is selected, the title will be faded in
or out. The LED lights up when this switch is selected.