Werbung
Verfügbare Sprachen
Verfügbare Sprachen
In case
the title card is written with black on white,
slide the Key Level Control from lower position.
KEY
LEVEL
VIDEO | | |
t
When the optional Character Generator WV-KB12
or WJ-TTL5
is only used
for the superimpose,
the Key Level Control (30) will not effect to the
superimposing.
TITLE CARD
2.
REVERSE EFFECT
e
Select the polarity of the key signal to be superimposed
by pressing the Reverse Switch (21).
Becomes the title colour
Original Picture
Title
Superimposed Picture
Original Picture in the title
3.
TITLE EFFECT
e
If desired,
the edge enhancement
of the title can
be obtained by pressing the Title Effect Switch (29)
repeatedly.
The effected picture will be as follows.
Normal —
Narrow Border — Wide Border >
~+ Narrow Shadow — Wide Shadow — Drop Shadow zi
Normal
Narrow Border
Wide Border
[A+
(A> AAP
Narrow Shadow
Wide Shadow
*/\9 (\-»
Notes:
(1)
The
superimposed
titles
by
the
Character
Generator can be coloured. Press the Back Colour
Switch (27) and select the colour by the Back
Colour Selection Switch (5).
When
the White
Colour
Switch
(28) is pressed
for the superimposed
titles by the Character
Generator,
the edge
of the characters
can
be
coloured by the Back Colour Selection Switch (5).
Drop Shadow
(2)
SES
D. FADE CONTROL
(Fave
CONTROL CF
IN
(— COLOUR SELECT
a
VIDEO ~—- BACK COLOUR
Press the Effect Recording Video Output Selection
Switches (33).
Press either the Mix Mode Selection Switch (52) or the
Wipe Mode Selection Switch (53).
Select the source signal for A-bus and B-bus from the
SOURCE 1, SOURCE 2 or BACK COLOUR,
In case that the back colour is selected, set the Back
Colour Selection Switch (5) to the desired colour.
Fading Operation
e
Select the combination of the switches (37) and (38)
whether picture and title are to be faded in and out
or only picture or only title. The following table shows
which button must be pressed.
ail vineo_ |
ON
OFF
OFF
ON
x [on
e
When the Video Fade Switch (37) is pressed, the display
monitor has a choice from BACK COLOUR (34) WHITE
(35) or BLACK (36).
In case that the BACK COLOUR
has been chosen,
select the desired colour by the Back Colour Selection
Switch (5).
Slide the Fade Lever (39) from IN to OUT, or vice versa.
TITLE
|
VIDEO fade
TITLE fade
VIDEO & TITLE fade
|
Werbung
