Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5-2.
C.
(1)
(2)
Press
the
B-bus
Mosaic
ON/OFF
Switch
(18) and
adjust the size of the rectangles by pressing the B-bus
Mosaic ON/OFF Switch (18) repeatedly.
Press the Wipe Mode Selection Switch (53).
Select the Circle or Square wipe using Wipe Pattern
Selection Switches (6).
Operate the Mix/Wipe Control (45) for desired wipe
size.
Operate the Joystic Positioner (54) to position the wipe
position on the screen.
SUPERIMPOSE EFFECT & BACK
COLOUR
BACK COLOUR
———=—2>-
° e ° < EJ ef baal m is)
EXT
TITLE
AEVERSE
CAMERA
EFFECT
Press
the Effect Recording
Video
Output
Selection
Switch (33).
Press either the Mix Mode Selection Switch (52) or the
Wipe Mode Selection Switch (53).
(3)
(6)
Select the background
image.
Set Mix/Wipe Control
(45)
to
lower
position
(B)
for
B-bus
image
as
background
or upper position (A) for A-bus image as
background.
The background
image can be selected
from the SOURCE 1, SOURCE 2 or BACK COLOUR for
either position of A-bus or B-bus.
Select
the
key
image
source
(the
one
to
be
superimposed) by pressing one of the Superimpose
Source Selection Switches (23), (24), (25).
Note:
In case the Character Generator is used, connect
it to the Title Input Connector (2).
In case
the back
colour
is to be selected,
set the
Back Colour Switch (27) to the desired colour or White
Colour Switch (28).
Select the colour using Back Colour Selection Switch
(5).
Caution:
Do not simultaneously press the BACK COLOUR
switch
for the
A-bus
(B-bus
) and
the
BACK
COLOUR switch for the superimpose function.
Press the Superimpose ON/OFF Switch (22) once to
enter the function.
Remark:
When the B-bus Back Colour Selection Switch
(47) is selected after the B-bus Source 2 Selection
Switch
(49),
the
LED
on
the
B-bus
Source
2
Selection Switch (49) blinks.
This blinking tells you that the Source 2 picture will
be selected when the B-bus Selection Switch (25)
is pressed.
The same procedure will take place
when A-bus or Source 1 is used.
SUPERIMPOSE BY CAMERA
Connect
the camera
with
cable
to the
Composite
Video External Camera
Input Connector
(64) or the
Y/C External Camera Input Connector (63).
Direct the camera at a picture or panel.
Press External Camera Selection Switch (23).
While observing the image on a video monitor, which
is connected
to the the Preview Output Connector
(72), adjust the Key Level Control (30) until a clear
superimposed image is obtained.
In case the title card is written with white letters on
black, slide the Key Level Control from upper position.
KEY
LEVEL
Y
TITLE CARD
Werbung
