Werbung
Verfügbare Sprachen
Verfügbare Sprachen
VIDEO
8-2. Cut-Multi wipe
Press
the Effect
Recording
Video
Output
Selection
Switch (33).
Press the Wipe Mode Selection Switch (53).
Select the source signal for A-bus and B-bus from the
SOURCE 1, SOURCE 2 or BACK COLOUR,
In case that the back colour is selected, set the Back
Colour Selection Switch (5) to the desired colour.
Confirm
that the
LED
indicator
of the Video
Fade
Switch (37) lights off.
Do not select any wipe pattern from the Wipe Pattern
Selection Switches (6).
Press the Multi Wipe Switch (8) once.
Slide the Mix/Wipe Control (45) from A position to
B position slowly.
The 1/4 sized A-bus picture will
appeare as shown.
(=i
iS
rm re]
(=F
:
&
i< iS im
fo}
(10
iS
js]
im
1°]
=]
(==
Note:
When the Multi Wipe Pattern Switch (8) is pressed
twice,
a 1/16 sized picture
performs
the same
manner.
Remarks:
(1)
When the B-bus Back Colour Selection Switch
(47) is selected after the B-bus Source 2 Selection
Switch
(49),
the
LED
on
the
B-bus
Source
2
Selection Switch (49) blinks.
This blinking tells you that the Source 2 picture will
be selected when the B-bus Selection Switch (25)
is pressed.
The same
procedure will take place
when A-bus or Source 1 is used.
(2)
When
the B-bus
Still ON/OFF
Switch
(14) is
pressed
while
the
B-bus
Source
2 Selection
Switch (49) has been selected, B-bus Source 1
Selection Switch (51) will not function.
The same
procedure will take place when A-bus or Source
1 is used.
DIGITAL EFFECT
STROBE
MOSAIC
"|
The following Effects will be mainly explained for A-bus
picture as a example.
(1)
(2)
(3)
(4)
(5)
Press the Mix Mode Selection Switch (52).
Press A-bus Source 1 Selection Switch (50).
Slide Mix/Wipe Control (45) to A position.
Press the A-bus Digital Effect ON/OFF Switch (11).
Press the Effect Recording Video Output Selection
Switch (33).
STILL
.
Press
the A-bus
Still ON/OFF
Switch
(13) once
to
freeze the picture. The LED lights up.
Werbung
