Werbung
Verfügbare Sprachen
Verfügbare Sprachen
57.
58.
59.
60.
61.
62.
63.
Source 1 Video Input Connector
(SOURCE 1, COMP.IN)
A 1.0 Vp-p/75 ohms composite video signal should be
supplied to the input (IN) connector.
Notes:
(1)
If the input signal does not meet the PAL colour
standard or the CCIR B/W standard, this could
cause synchronization error.
(2)
Incase the S/N ratio of the input signal is very low,
this may reflect to in a low-quality picture.
(3)
If the input video signal is very jittery, such as a
picture played back on a VTR, synchronization or
colour error may appear.
Source 1 Video Output Connector
(SOURCE 1, COMP. MONITOR OUT)
A 1.0Vp-p/75 ohms composite video signal will be
supplied at this connecter for the monitoring purpose
of the Source 1 Video Input signal.
Source 2 Audio Connectors
(SOURCE 2, AUDIO L/R)
~—6 dBV/15 kohms audio signals for the SOURCE
2
should
be supplied
to these
input (IN) connectors.
When
the
monophonic
audio
signal
is fed
to the
L-channel,
this
signal
will
be
distributed
to
the
R-channel internally.
Source 2 Y/C Video Input Connector
(SOURCE 2, Y/C IN)
The luminance (Y) and chroma (C) signals from VTR or
colour TV should be supplied to this connector.
Note:
The Y/C input has a priority over the composite
input in circuitry.
When both the Y/C video signal and the composite
video
signal
are
supplied
to
the
Source
2
connectors at the same time, only Y/C video signal
goes into the circuit.
Source 2 Video Input Connector
(SOURCE 2, COMP. IN)
The
IN connector
accepts
a
1.0
Vp-p/75
ohm
composite video signal.
Notes:
(t) If the input signal does not meet the PAL colour
standard or the CCIR B/W standard, this could
cause synchronization error.
(2)
Incase the S/N ratio of the input signal is very low,
this may reflect to in a low-quality picture.
(3)
If the input video signal is very jittery, such as a
picture played back on a VTR, synchronization or
colour error may appear.
Source 2 Video Output Connector
(SOURCE 2, COMP. MONITOR OUT)
A 1.0 Vp-p/75 ohms composite video signal will be
supplied at this connector for the monitoring purpose
of the Source 2 Video Input signal.
Y/C External Camera Input Connector
(EXT CAMERA IN Y/C)
The luminance (Y) and chroma (C) signal from VTR or
colour TV should be supplied to this connector.
64.
65.
66.
67.
68,
69.
70.
71.
72.
73.
Note:
1.
The Y/C input has a priority over the composite
input in circuitry.
When both the Y/C video signal and the composite
video signal are supplied to the External Camera
Input connectors at the same time, only Y/C video
signal goes into the circuit.
2.
This input accepts only video camera
signal and
will not accept VTR playback signal.
Composite Video External Camera Input Connector
(EXT CAMERA IN COMP.)
For
the
key signal
in the
superimpose
mode,
this
connector
accepts
a 1.0 Vp-p/75
ohms
composite
video signal.
The external sync is not necessary for
the camera.
Note:
This input accepts only video camera signal and
will not accept VTR playback signal.
Auxiliary Audio Input Connectors (AUX AUDIO IN)
Accept 6 dBV/15 kohms audio signal from an external
audio source. When the monophonic audio signal is fed
to the L-channel, this signal will be distributed to the
R-channel internally.
Recording Audio Output Connectors
(AUDIO OUT 1, L/R)
—6
dBV/1
kohms
audio
signals
for recording
are
supplied at these connectors.
Y/C Recording Video Output Connector
(REC VIDEO OUT 1, Y/C)
The luminance (Y) and chroma (C) signals are obtained
from this connector when composite or Y/C signal is
supplied to source 1 or 2.
Recording Video Output Connectors
(REC VIDEO OUT 1, COMP.)
A 1.0 Vp-p/75 ohm composite video signal, as selected
by the Recording Video Output Selection Switches (31),
(32), (33), is provided at these connectors.
Recording Audio Output Connectors
(AUDIO OUT 2, L/R)
—6
dBV/i
kohms
audio
signals for recording
are
supplied at these connectors.
Y/C Recording Video Output Connector
(REC VIDEO OUT 2, Y/C)
The luminance (Y) and chroma (C) signals are obtained
from this connector when composite or Y/C signal is
supplied to source 1 or 2.
Recording Video Output Connectors
(REC VIDEO OUT 2, COMP.)
A 1.0 Vp-p/75 ohm composite video signal, as selected
by the Recording Video Output Selection Switches (31),
(32), (33), is provided at these connectors.
Preview Output Connector (PREVIEW OUT)
A 1.0 Vp-p/75
ohm composite video signal of the
EFFECT (all effect) image is provided at this connector.
Power Cord
Werbung
