Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A-bus
B-bus
B-bus
P-IN-P WIPE
Press the Effect Recording Video Output Selection
Switch (33).
Press the Wipe Mode Selection Switch (53).
Select the source signal for A-bus and B-bus from the
SOURCE 1, SOURCE 2 or BACK COLOUR.
In case that the back colour is selected, set the Back
Colour Selection Switch (5) to the desired colour.
Confirm
that the LED
indicator
of the Video
Fade
Switch (37) lights off.
Press the Picture-In-Picture Switch (7).
When the switch is pressed once and the Mix/Wipe
Control (45) is positioned in B, a 1/4 sized B-bus picture
will be inserted into A-bus picture as shown below.
;
[= |
~12-
By sliding the Mix/Wipe Control (45) to A position in this
conditions, the inserted picture B will be changed
to
A-bus picture as shown below.
B.
Press the Picture-In-Picture Switch
a 1/16 sized picture for insertion.
7) again to obtain
7
The position of those 1/4 or 1/16 sized picture can be
freely set using a Joystic Positioner
(54).
Notes:
(1)
When
a 1/4 or 1/16 sized picture is positioned
to the left edge, the P-IN-P mode may not be
performed in the fringe area for some
television
monitor.
EI
(2)
The image of the inserted picture may be slipped
into two in horizontal depending on the position of
the inserted picture.
(3)
Incase that the B-bus picture is inserted in A-bus
picture and,
1)
when
A-bus
Recording
Video
Output
Selection Switch (31) is pressed, only A-bus
picture will be output.
2) when
B-bus
Recording
Video
Output
Selection Switch (32) is pressed, the inserted
B-bus picture with black back ground will be
output.
Remark:
The Strobe and the Still will not function when the
picture-in-picture mode is used.
Werbung
