Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MULTI WIPE
Press
the Effect
Recording
Video
Output
Selection
Switch (33).
Press the Wipe Mode Selection Switch (53).
Select the source signal for A-bus and B-bus from the
SOURCE 1, SOURCE 2 or BACK COLOUR.
In case that the back colour is selected, set the Back
Colour Selection Switch (5) to the desired colour.
Confirm
that
the
LED
indicator
of the
Video
Fade
Switch (37) lights off.
Select the desired wipe pattern using the Wipe Pattern
Selection Switches (6).
B [Al
Then press the Multi Wipe Pattern Switch (8) once to
obtain a four times of multiplied wiped pattern.
Es
[a] [A]
If the Multi Wipe Pattern Switch (8) is-pressed again,
sixteen
times
of multiplied
wiped
pattern
will
be
obtained.
REVERSE WIPE
When this switch is pressed, the position of the wiped
pictures will be laid reversely.
~413-
7.
ONE-WAY WIPE
When this switch is pressed, the wiping direction stays
same
in regardless
of the
moving
direction
of the
Mix/Wipe Control (45).
VIDEO
VIDEO
WIPE MODE
There is a choice of wipe mode from a Soft wipe or Border
wipe.
e
e
Press the Wipe Mode Selection Switch (53) twice to
obtain a clear/wide edge. A choice of the colour on
this border edge is available from the Back Colour
Selection Switch (5).
Press the Wipe Mode Selection Switch (53) third time
to obtain a dimmed wiping edge. To return to a normal
wipe mode, press the Wipe Mode Selection Switch (53)
again.
APPLICATION
. Cut Wipe
Press the Effect Recording Video Output Selection
Switch (33).
Press the Wipe Mode Selection Switch (3).
Select the source signal for A-bus and B-bus from the
SOURCE 1, SOURCE 2 or BACK COLOUR.
In case that the back colour is selected, set the Back
Colour Selection Switch (5) to the desired colour.
Confirm
that
the LED
indicator
of the Video
Fade
Switch (37) lights off.
Do not select any wipe pattern from the Wipe Pattern
Selection Switches (6).
Slide the Mix/Wipe Control (45) up and down near
the center position. The A-bus picture and the B-bus
picture appear by turns.
Werbung
