Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PRECAUTIONS
DON'T
DO'S
DO not attempt to disassemble the instrument. In order
to prevent electrical shock, do not remove screws or
covers. There are no user-serviceable parts inside.
Do not abuse the instrument.
Avoid striking, shaking,
etc.
It could
be damaged
by improper
handling
or
storage.
Do
not
use
strong
or
abrasive
detergents
when
cleaning the instrument body.
Do not expose the instrument to water or moisture, and
do not operate it in wet areas of it is wet.
Do not use the instrument in an extreme environment
where high temperature or high humidity exist.
Do refer al! servicing to qualified service personnel.
Do handle the instrument with care.
Do use a dry cloth to clean the instrument when dirty.
In case the dirt is hard to remove, use mild detergent
and wipe gently.
Do take immediate action if ever the instrument does
become
wet.
Turn the power off and refer servicing
to qualified service personnel.
Moisture can damage
the instrument and also create the danger of electric
shock.
Use
the
instrument
under
conditions
where
temperatures are within O°C - 40°C, and humidity is
below 90%.
Important Notice for Source 1 and 2 Video Signal:
(1)
(2)
(3)
If the input video signal does not meet with the PAL
colour standard or the CCIR B/W standard video signal,
this could cause a disturbance of synchronization.
If the signal to noise ratio (S/N) of the input signal is
very low, this may be reflected in a low quality picture.
lf the input video
signal is very jittery, as in the
case of poor VTR playback signal, this could cause
a disturbance in synchronization or colour.
lf the tracking noise is seen on the TV monitor, this
could cause a disturbance in synchronization or colour
so that adjust the tracking control of the VTR.
When
either
a
character
generator
signal
(from
WV-KB12- WJ-TTL5) or characters from a key camera
is supplied, the edge of the character
might become
rough as shown
below
under the certain electronic
conditions.
(6)
(7)
Flag waving (top of picture curls) may appear when
certain VTR's are used as input signals (due to skew
errors) or may appear due to the characteristics of the
video monitor (due to AFC time constants).
V4
The edge of the hard and border wipe in the circle wipe
mode will be a zigzag. This phenomenon is normal and
not a sign of failure.
Werbung
