Yamaha GEP50 Bedienungsanleitung Seite 8

2: GENERAL OPERA TION
/MEMORY CONFIGURATION?
The GEP50 has a total of 100 internal memory locations.
Locations 1 through 50 are READ-ONLY MEMORY containing
the 50 preset effect programs. These locations cannot be
written to or changed in any way. The effect programs con--
tained in memory locations 1 through 50 are:
Mem.
No.
Program Name
Mem.
No.
Program Name
1 Mid-Band Drive
26 Rev 2 Hall
2
Heavy Metai 27 Rev 3 Room
3 Punk Dist.
28 Rev 4 Vocal
4 Light Dist. 29
Rev 5 Vocal
5 Hard Overdrive 30 Rev 6 Plate
6 Chunky Rhythm
31 Early Ref. 1
7 Sweet Sustain 32
Early Ref. 2
8 Punchy Lead
33 Early Ref. 3
9 Smooth Drive 34 Early Ref. 4
10 Overdrive Hali 35
Delay Short
11
Distortion Room 36 Delay Long
12 Live Djst. 37 Echo Short
13 E/R Distortion 38
Echo Long
14 Slide Gate 39 Stereo Flange
15
Stow Gate Dist. 40
Chorus
16 Reverse Dist. 41
Stereo Phasing
17 Delay Dist.
42 Symphonic
18
Dist. Filter 43
Gate Reverb
19 Double Dist.
44 Reverse Gate
20
Max-Delay Dist. 45
Compressor
21 Flange Dist.
46 Rev & Gate
22 Chorus Dist.
47 Pitch A
23
Phase Dist. 48 Pitch B
24 Symphonic Dist.
49 Pitch C
25 Rev 1 Hall
50 Parametric EQ
A complete description of each effect program and its parame¬
ters is given in "3: DESCRIPTIONS OF THE EFFECT PRO¬
GRAMS & THEIR PARAMETERS" ON PAGE 13. Locations 51
through 00 are READA/VRITE MEMORY which can be used to
store your own Odited versions of the preset programs.
/
SELECTING AN EFFECT/MEMORY
/
/
LOCATION
_ /
® Press the MEMORY button to engage the memory selection
mode. This is not necessary if the memory selection mode
is already active, but it's a good habit to get into to ensure
smooth operation.
® Press the|A] or button to increment or decrement the
memory location number shown on the LED display. Hold
either of these buttons down for continuous incrementing or
decrementing. The name of the program corresponding to
the currently selected memory location wili be shown on the
LCD, or " *** NO DATA
"
wiii be displayed if a mem¬
ory location between 51 and 00 is seiected into which an
edited effect program has not been stored. Note that at this
stage the LED memory number display is flashing, indicating
that aithough a new iocation has been selected, its contents
have not yet been recalled.
When the desired memory location/effect has been selected,
press the RECALL button. The LED memory number display
will stop flashing and the selected effect will be engaged.
MEMORY
I
D C
C O
Rev 2 Hall
r
A
V
t 1
I 1
Distortion Room
Selected Effect
\
,
RECALL
r
1 1
1 1
Distortion Room
GEP50 GUITAR EFFECT PROCESSOR