Yamaha GEP50 Bedienungsanleitung Seite 15

21. Flange Dist.
22. Chorus Dist.
Flange plus distortion. Chorus plus distortion.
Distortion Level (DiSTORTiON): 0 — 100%
Sets the "degree" or "depth" of the distortion portion of the
effect.
Fiange Baiance (FLANGE BAL): 0
—
100%
Determines the amount of flange effect applied to the distor¬
tion sound.
Modulation Frequency (MOD. FRO): 0.1 HZ'— 20 Hz
Sets the speed of modulation, and hence the rate at which
the effect varies.
Modulation Depth (MOD. DEPTH): 0%
—
100%
Sets the amount of delay time variation, thus adjusting the
depth of the effect.
Modulation Deiay (MOD. DLY): 0.1 ~ 100 miiiisec-
onds
This sets the basic delay time from the initial direct sound to
the beginning of the flange effect.
Feedback Gain (F.B. GAiN): 0%
—
99%
Determines the amount of flange signal which is fed back to
the input of the processor for further modulation. More
feedback increases the overall complexity, "strength" and
decay time of the effect.
Trigger Levei (TRG. LEVEL): 1 — 100
Determines the amplitude of the input signal required to
trigger the effect. This parameter, in conjunction with the
RELEASE parameter below, functions effectively as a noise
gate to cut out hiss and noise when an input signal is not
present. TRG LEVEL should be set so that the effect is
activated only when a note is played on the instrument
used.
Reiease Time (RELEASE): 5 — 32000 miiiiseconds
Determines the amount of time it takes for the distortion
gate to close after the input signal drops below the trigger
level. Proper setting of the RELEASE parameter is essential
to allow a natural decay of the source instrument sound.
Distortion Level (DiSTORTiON): 0 —100%
Sets the "degree" or "depth" of the distortion portion of the
effect.
Chorus Balance (CHORUS BAL): 0
—
100%
Determines the amount of chorus effect applied to the
distortion sound.
Modulation Frequency (MOD. FRO): 0.1 Hz — 20 Hz
Sets the speed of chorus effect variation.
Delay Modulation Depth (DM DEPTH): 0% — 100%
This sets the depth or "strength" of the chorus effect.
Amplitude Modulation Depth (AM DEPTH): 0% —
100%
Sets the amount by which the amplitude (level) of the input
signal is varied.
Trigger Level (TRG. LEVEL): 1 — 100
Determines the amplitude of the input signal required to
trigger the effect. This parameter, in conjunction with the
RELEASE parameter below, functions effectively as a noise
gate to cut out hiss and noise when an input signal is not
present. TRG LEVEL should be set so that the effect is
activated only when a note is played on the instrument
used.
Release Time (RELEASE): 5 — 32000 miiiiseconds
Determines the amount of time it takes for the distortion
gate to close after the input signal drops below the trigger
level. Proper setting of the RELEASE parameter is essential
to allow a natural decay of the source instrument sound.
16