Maintenance And Care - Rational iCombi Pro 6-2/3 Original Installationsanleitung

English
02/2023) and iCombi Pro XS (from
20/03/2023) [
Check jumper on X401 and X402.
5

Maintenance and care

CAUTION
Sharp-edged panels
Risk of cuts when taking off the
condensation hood lid.
Wear protective gloves during
installation and maintenance.
WARNING
Non-regular cleaning of the
condensation hood
Risk of fire due to dirty condensation
hood.
Clean the condensation hood regularly
according to the manufacturer's
recommendations.
a
All units are switched off and free of
voltage.
a
The UltraVent / UltraVent Plus is dis-
connected from the mains.
1. Remove the mesh filter
[ Figure 27
2. Clean the mesh filter [
>
If the mesh filter is too dirty, it
must be replaced.
3. Loosen the 2 marked screws and re-
move the lid of the condensation hood
[ Figure 29].
4. Clean the top side in the dishwasher.
16 / 108
Figure 34]:
].
Figure 28
80.51.597_iCombiPro-iCombiClassic_IntegrationKit_IM_EU-west
5. Spray the interior of the condensation
hood using the hand shower
[ Figure
6. Attach the cover of the condensation
hood.
Replacing the HEPA filter
a
The yellow LED indicates when the
HEPA filter needs to be replaced
[ Figure
a
The unit on which the condensation
hood is to be installed is disconnected
from the mains.
a
The condensation hood is disconnec-
ted from the mains.
1. Disassemble the stem.
2. Loosen the 2 marked screws
[ Figure
3. Pull out the filter unit and open the 2
screws [
4. Replace the HEPA filter [
].
5 | Maintenance and care
30].
23].
24].
Figure 25].
Figure 26].