Hach TenSette plus Benutzerhandbuch Seite 6

Figure 1 Install the battery
4.2 Connect to power
Explosion and fire hazard. Battery substitution is not permitted. Use only batteries that
are supplied by the instrument manufacturer.
Fire and explosion hazard. Lithium batteries may get hot, explode or ignite and cause
serious injury if exposed to abuse conditions.
Use only the original Hach TenSette plus charger and battery.
The pipette battery must be charged before initial use. You can use the pipette while the charger is
connected. The charging time is typically less than one hour. An indicator in the LCD display shows
the charge level of the battery. When the indicator shows an empty battery, pipetting is not possible,
and the pipette must be charged again.
1. Connect the lead of charger to the socket on the back of the pipette.
2. Connect the charger to an AC wall socket.
Note: If the battery is completely empty, it may take a few minutes before the pipette will turn on.
4.3 Adjust the trigger position
The index finger-operated trigger, which activates the piston movement, can be adjusted by rotating
it 60 degrees in both directions from the center position. Usually right-handed operators turn it left
(counter-clockwise) to get the best possible position for the thumb to eject the tip. Refer to
6 English
W A R N I N G
W A R N I N G
N O T I C E
Figure 2.