Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E. MEMORY
WJ-MX12
has a feature of MEMORY
which is a memory
for a programmable operating precedure.
Four kinds of programs can be memorized and this four pro-
grams can store up to fifty-five procedures.
By this func-
tion, WJ-MX12 operates a Effect procedure automatically
as they are programmed.
e
Set the mode switch © to PRG position.
e
Select and press the function button, for example press
STROBE @, then push No.1 switch of the MEMORY
@®. The letter of '1' will light up one second.
e
Repeat above precedures.
e
Adjust RUN
SPEED control
© as desired.
The Run Speed for each procedure can be adjusted
from 0.05 sec. (Min.) to 1 sec. (Max.).
e
Press No.1
button ® again to start the operation.
4
Remarks:
3.
Incase of memorizing
a AUTO TAKE @ function, press
this switch first than memorize it after completing the
auto-take function.
4.
Once the mode switch ® is set to PRG position, the
present
program
is ready to be overwritten
by new
program.
Ao
F. AUDIO MIXER
The following is a block diagram depicting the circuitry of the
audio section.
BALANCE
AUDIO
airy :
AUDIO 1
MAX
s
REC
OUT
LR
SOURCE 2
AUDIO 2
LR
AUDIO
FADE
AUX |
AUX
AUDIO
, 5
MAX
HEAD-
+>
PHONE
MIC
MIC
(MONO)
MIN
MIN
e
Torecord the SOURCE 1 audio signal, set the Balance
control @ to the end position "AUDIO
1'", and adjust
the audio level by operating the Audio Level control @.
e
To mix the SOURCE
1 and SOURCE 2 audio signals,
adjust the Balance control @.
e
To mix the auxiliary audio signal for recording, adjust the
AUX Level control @.
e
To mix the microphone signal for recording, adjust the
MIC Level control @.
e
To fade in or fade out the audio signal, press the AUDIO
switch of the Fade Selection switches @ and operate the
Fade Lever @.
e
To adjust the headphone output level, operate the Head-
phone Level control @.
Werbung
