Werbung
Verfügbare Sprachen
Verfügbare Sprachen
B. SUPERIMPOSE EFFECT & BACK COLOUR
2)
3)
4)
5)
Set the Input Mode Selection switch ® to 2=8% or
200b9
Note: In case you want to process the SOURCE 1 video
signal with digital effects (e.g., Mosaic, Paint),
select 2=8%. Select 28689 for the SOURCE
2
video signal.
Press the EFFECT switch of the Recording Video Out-
put Selection switch @.
Press either the MIX or the WIPE switch of the Mix/
Wipe Mode Selection switches @.
Select the background image. Set Wipe/Mix lever to
lower position ( B ) for B-bus image as background or
upper position ( A ) for A-bus image as background. The
source can be selected from the VIDEO 1, VIDEO 2 or
BACK COLOUR
for either position,
@ @.
Select the key image source (the one to be super-
imposed)
by pressing one
of the Source
Selection
switches @: VIDEO
1, VIDEO 2 or EXT CAMERA.
Note:
Incase the Character Generator is to be used,
connect it to the Title Input connector @.
6)
7)
= ha
Character Genenator
WV-KB12
In case BACK COLOUR is selected, set the Back Colour
Selection switch @) to the desired colour or white pic-
ture @.
Select the colour using BACK Colour Selection switch
@ and adjust the colour level using Chroma control @.
Caution: Do
not
simultaneously
press
the
BACK
COLOUR
switch for the A-bus (B-bus) and
the
BACK
COLOUR
switch
for
the
superimpose function.
Press the Superimpose
ON/OFF
switch
@ once to
enter the function.
Superimpose by Camera
Connect the camera to EXT CAMERA input 6 and con-
nect the sync signal from SYNC OUT @ to the camera
as well.
Direct the camera at a picture or a panel.
Press EXT CAMERA
switch @.
While observing the image on a video monitor, which is
connected to the Preview Output connector @, adjust
the Key Level control (LOWER/UPPER) ® until a clear
superimposed image is obtained.
In case the title card is written with white letters on
black, set the UPPER lever of the Key Level control to
the HIGH end, and adjust the LOWER lever for a clear
superimposed picture.
KEY LEVEL
LOWER
UPPER
V1 B) = @)
x
PEEP
IP
titi?
olllititill
fo =
TITLE CARD
In case the title card is written with black on white, set
the LOWER lever to the LOW end and adjust the UPPER
lever for a clear superimposed picture.
KEY LEVEL
LOWER
UPPER
z ° x
VIDEO
x
PEPEtbtt
tig
°o
€
c
°
«
TITLE CARD
Note: When
the optional Character
Generator WV-
KB12
is only used for the superimpose, set both
levers to the LOW end.
Werbung
