Stihl RMI 632.0 Gebrauchsanleitung Seite 152

During the active times, third
parties must keep out of the danger
area. The active times should be
adapted accordingly.
Moreover, the applicable local
regulations on the use of robotic
mowers as well as the information
in the "For your safety"
section ( 6.) must be observed
and the active times changed
accordingly in the "Mowing plan"
menu as required. (
In particular, you should check the
times of the day and night at which
it is permissible to use the machine
with the responsible authorities.
14.4 Mowing duration
The mowing duration specifies how many
hours per week the lawn is to be mown. It
can be extended or reduced in the weekly
settings ( 11.8).
The mowing duration corresponds to the
time during which the robotic mower mows
the lawn. Times during which the battery is
charged are not part of the mowing
duration.
During initial installation, the robotic
mower automatically calculates the
mowing duration based on the specified
size of the mowing area. This reference
value is based on a normal lawn under dry
conditions.
Mowing performance:
2
For 100 m , the robotic mower needs on
average:
RMI 632, RMI 632 C:
RMI 632 P,
RMI 632 PC:
150
14.5 Home area (RMI 632 C,
RMI 632 PC)
The robotic mower identifies its location
using the built-in GPS receiver. During
each edge following run to check the
correct wire routing (
entering in the starting points (
the robotic mower stores the coordinates
of the most westerly, easterly, southerly
and northerly point.
11.7)
This area is defined as the home area and
the robotic mower can be used here. The
coordinates are updated each time edge
following is repeated.
When GPS protection is activated, the
owner of the machine is notified if the
machine is operated outside the home
area. The PIN code is also requested on
the robotic mower display.
14.6 Manual mowing
Do not activate the mowing blade or set
the lowest cutting height in high grass.
The robotic mower load must never cause
the mowing motor speed to drop
significantly. If the speed drops or the
robotic mower slows down, select a higher
cutting height setting.
15. Operating the machine
15.1 Preparation
An installation assistant is available
70 minutes
for initial installation. (
60 minutes
● Install the docking station (
● Route (
9.13) and when
11.15),
● Remove foreign bodies (e.g. toys,
● Charge the battery (
● Set the time and date (
● Check the mowing plan and adapt if
15.2 Removing and installing the
control panel
The control panel can be removed from
the robotic mower as required in order to
perform manual mowing or to e.g. change
the programming.
Automatic operation of the robotic mower
is only possible when the control panel is
inserted.
Removing the control panel:
● In running operation, press the STOP
9.)
The robotic mower should be
charged and operated at an
ambient temperature between +5°C
and +40°C.
9.10) and connect (
the perimeter wire
tools) from the mowing area
15.8)
11.11)
necessary – in particular it must be
ensured that third parties keep away
from the danger area during active
times. ( 11.6)
Mow very high grass until it is short
using a conventional lawn mower
prior to use of the robotic mower
(e.g. following a lengthy break).
button before removing the control
panel.
0478 131 9942 C - EN
9.9)
9.11)