Würth MM 230 Originalbetriebsanleitung Seite 19

Overload indicator
If the temperature control indicator [35] lights up on
pressing the welding torch button, this is a signal for an
appliance overload. Allow the appliance to cool down
in no-load mode.
Maintenance / Care
Important!
The device may only be cleaned with the
mains plug disconnected.
Keep device and ventilation slots clean.
In the unlikely event of a failure or defect, have the
appliance examined and repaired by an authorised
customer service point for Würth tools.
In all your queries and spare part orders, always quote
the product number (see type plate) of your device.
Environmental protection
Do not dispose of the device with
domestic waste. Have the device
disposed of by an authorised waste
management company or your
municipal waste management organi-
sation. Adhere to the applicable
regulations. In case of doubt contact
your waste management organisation. Recycle all
packaging material in an environmentally friendly
manner.
Warranty
This Würth device is covered by warranty according
to the applicable national regulations. The warranty
period begins on the date of purchase (please retain
invoice or delivery note as proof of purchase).
Faults covered by warranty shall be eliminated by
replacement or repair. Damage caused by improper
operation is not covered by warranty.
Claims can be recognised only if the device is in a non-
disassembled state and presented to a Würth branch
office, your Würth sales representative or a customer
service office authorized by Würth.
Technical changes reserved.
We accept no liability for printing errors.
Spare parts
In the unlikely event of a failure or defect, have
the device repaired by a Würth masterService
workshop.
In all your queries and spare part orders, always
quote the product number (see type plate) of your
device.
The current spare parts list of the device can be
viewed online at
http://www.wuerth.com/partsmanager.
Alternatively, contact your local Würth agency for a
hardcopy.
Declaration of Conformity
We herewith declare that this product conforms with
the following standards and directives:
Standards
• EN 60974-1:2012
• EN 60974-2:2013
• EN 60974-10:2014 CL.A
in accordance with the regulations stipulated in the
directives:
EU directive
• 2011/65/EU
• 2014/35/EU
• 2014/30/EU
• 2019/1784/EU
Technical documentation at:
Adolf Würth GmbH & Co. KG, Abt. PCV
Reinhold-Würth-Straße 12 – 17,
74653 Künzelsau, Germany
Alexander Kimmig
Head of Machines -
Services and Systems
Authorised Signatory
Künzelsau: 01.01.2021
Dr.-Ing. S. Beichter
Director Quality
Authorised Signatory
19