Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Please read this instruction manual
before using the device for the first
time and comply with it.
Keep this instruction manual for future
reference or for subsequent posses-
sors.
Note
It is not allowed to modify the appliance.
Modifications can cause injuries and
malfunctions.
Only authorised and trained personnel are al-
■
lowed to repair the appliance. Only use genuine
spare parts from Adolf Würth GmbH & Co. KG.
This is to ensure and maintain safe operation of
the device.
Before starting welding, remove all solvents,
■
thinners, degreasing agents and other flammable
materials from the work site. Cover all stationary
flammable materials. Welding work may only be
performed when the ambient air does not contain
high concentrations of dust, acid vapours, gases
or flammable substances. Extra care is required
when performing repair work on pipe systems and
containers which contain or contained flammable
liquids or gases.
Protect the appliance from rain. Do not hose it
■
down or clean it with a steam or water jet.
Never perform welding work without using a
■
welding shield. Warn all persons in the vicinity
about the electric arc rays.
Use suitable extraction equipment for gases and
■
cutting vapours. Use breathing equipment if there is
the danger of inhaling welding or cutting vapours.
If the power cord becomes damaged while
■
working, do not touch the cable but pull the mains
plug instantly. Never use the appliance when the
power cord is damaged.
Always have a fire extinguisher within reach.
■
Perform a fire-check after completing welding work
■
(see applicable accident prevention regulations).
Never try to dismantle the pressure reducer.
■
Replace the pressure reducer if it is defective.
Ensure good and direct contact of the workpiece
■
line in the immediate vicinity to the welding spot.
For your safety
Disregarding this instruction manual and the safety
instructions may result in damage to the device and
may cause dangerous situations for the operator
and other people. In case of transport damage
inform your vendor immediately.
Safety instructions
Never direct the welding current through chains,
ball bearings, steel cables, protective conductors
etc. as they may melt.
Protect yourself and the appliance when working
■
on raised or tilted work surfaces.
The appliance may only be connected to a prop-
■
erly grounded mains supply. (Three-phase four-wire
system with grounded neutral conductor or
one-phase three-wire system with grounded neutral
conductor). The protective conductor for the socket
and the extension cable must be in working order.
Wear protective clothing, leather gloves and
■
leather apron.
Never use the welding machine to thaw frozen
■
pipes or lines.
For work in closed containers or in confined spaces
■
or when there is an increased electrical hazard,
only devices with the
During breaks the appliance should be switched
■
off and the valve of the gas cylinder should be
closed.
Use the safety chain to secure the gas cylinder
■
against falling over.
Remove the gas cylinder before transport.
■
Pull the mains plug before moving the appliance or
■
performing work on the appliance.
To mark the appliance, do not drill holes into the
■
casing and do not attach rivets. Use stickers.
Only use genuine Würth accessories and
■
spare parts.
WARNING - Prior to the first
start-up, it is definitely necessary to
read the Safety instructions!
sign may be used.
S
13
Werbung
